Learn More
Cutter Material
Overall Length
Learn More
End Cut Type
Learn More
Cut Type
Cutting Diameter
International Shipping
Amazon Prime Eligibility

Square Nose End Mills

Square nose end mills have a square angle at the end, and create sharp, unrounded cuts in a workpiece.

Cutter material is an important consideration when selecting an end mill. Carbide can run at higher speeds than high-speed or cobalt steel, resisting wear… Learn More

Some end mills are uncoated, while others are coated with finishes to enhance performance. Most finishes extend the life of the end mill and allow higher cutting speeds and feed rates. For example, a titanium nitride (TiN) finish offers high-temperature resistance and increased hardness compared to uncoated end mills, while a titanium carbon nitride (TiCN) finish lubricates the end mill for high-temperature stability and offers better abrasion resistance than TiN coating.

An end mill’s end cut type is either center cutting or non-center cutting. Center-cutting end mills can create three-dimensional shapes and profiles, and make plunge cuts similar to a drill bit. Non-center-cutting end mills are suitable for peripheral milling and finishing, but cannot make plunge cuts.

The cutting diameter references the outside diameter of an end mill’s flutes. For tapered end mills, the cutting diameter is measured at the tip of the tool, not the shank.

There are three cut types for end mills. Finishing end mills provide a smoother surface finish than general purpose or roughing end mills. General purpose end mills can be used for a range of applications, and provide a smoother finish than roughers. Roughing end mills remove more material in less time than general purpose end mills, with minimal vibration (chatter). They create a rough finish that can be smoothed by a second finishing cut.

18,797 products grouped into 3,186 families
Prev 1 2 160 Next